Meyra 2.432 Spezifikationen PDF herunterladen (Seite 20)

20

SERVICE

LIGHTING CODE 932

Before replacing a faulty bulb, turn off

the light and pull out connector plug

(B, Fig. 62).

Headlight setting

The headlights should be set in such a

way that the light cone is visible on the

road. – The lower edge of the light

cone should be set at distance of 3 me-

ters to the front of the wheelchair.

Tools: screwdriver

– Loosen fastening screws C and

-– set headlights (Fig. 63)

-– tighten fastening screws.

Replacing a headlight bulb

Filament bulb:

24V/3W E10

Tools: Phillips screw driver

Removal:

– loosen fastening screw and remove

the headlight lens, (Fig. 64)

– pull the socket with bulb out of the

lens.

– Unscrew the faulty bulb from the sok-

ket, (Fig. 65).

Mounting:

– Screw the new bulb in the socket,

(Fig. 65). – The earth wire is positio-

ned above the thread of the socket.

– Place the socket with bulb in the lens.

– Mount the lens, (Fig. 64). – First in-

sert the top pins, then press the lens

downwards and screw into place.

Front indicator

Ball lamp:

24V/10W BA15s

Tools: Phillips screw driver

Removal:

– Loosen fastening screw and remove

the headlight lens, (Fig.66)

– Press the faulty ball lamp slightly in-

wards, turn and remove from the

socket.

Mounting:

– Insert a new ball lamp. – Push the

side pins (bayonet catch) into the fra-

me, exert slight pressure against the

spring and turn until the bayonet catch

clicks into place (Fig. 66).

– Mount the lens. – First insert the top

pins (Fig. 63), then press the lens

downwards and screw into place.

Rear indicator

Ball lamp:

24V/21W BA15s

Tools: Phillips screw driver

Removal:

– Loosen fastening screw and remove

the lens, (Fig. 67).

– Press the faulty ball lamp slightly in-

wards, turn and remove from the

socket.

Mounting:

– Insert a new ball lamp. –Push the

side pins (bayonet catch) into the fra-

me, exert slight pressure against the

spring and turn until the bayonet catch

clicks into place.

– Mount the lens. First insert the top

pins (Fig. 68), then press the lens

downwards and screw into place.

Back light

Filament bulb:

Festoon bulb 24 V/C5W S8.5

Tools: Phillips screw driver

Removal:

– Loosen fastening screw and remove

the lens, (Fig.67).

– Press the faulty bulb against a holding

frame and remove.

Mounting:

– Insert a new bulb. – Place one tip

into one hole on the fixture, then the

other tip into the other hole.

– Mount the lens. – First insert the top

pins (Fig. 68), then press the lens

downwards and screw into place.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Kommentare zu diesen Handbüchern

Keine Kommentare